OptiGrind CBN Sharpening Wheel
for Bench Grinders

OptiGrind CBN Sharpening Wheel

Here is how to put a Sharp Edge on M2, 10V, Powder-Metal Tools!

Always True, Straight, and Square
Doesn't get Smaller with Use
Steel Core is Factory Balanced to run Smoothly
Runs Cooler than a Stone Wheel
Grinds Fast, Leaves a Mirror Finish
Removes Less Steel each Sharpening - Tools Last Longer
All but Coarse have a 5/8" band of grit on the side of the wheel
Even grinds Carbide!
Wheel Lasts a Long Time
Mounting Flange and Washer included

Made in Europe

Coarse is 80/100 grit, Standard is 170/200 grit, Fine is 270/325,
SuperFine is 325/400 grit

Note: The 1.5" wide wheels do not allow the side cover to be installed on the wheel guard. If you want to use the complete wheel guard, please order a 1" wide wheel.

Setup Instructions Here

Not recommended for Lapidary use

If you have questions, please email me, or call me at 303-449-7170

CBN Wheel - 8" Diameter x 1.5" Wide

Includes the bushing to fit your grinder. Please select it below.

Please Choose Grit
Enter Grinder Shaft Size Here

CBN Wheel - 8" Diameter x 1" Wide

Includes the bushing to fit your grinder. Please select it below.

Choose grit
Choose bushing size
$9.95 Priority Shippingper order
Standard Ground within the USA

Don't like PayPal? email me to pay with your credit card

CBN wheelmounting flange for CBN wheel^A*L
All content on this site Copyright © 2003 - 2018 Cindy Drozda | All Rights Reserved | Do not use without permission